Define what needs to change
A customization review starts with the existing configuration and the requirement it cannot meet. Share any current model, drawing, sample or test result so the discussion stays specific.
Parameters to review
- Electrical supply and the speed–torque operating point.
- Shaft geometry, mounting interfaces, connectors and wiring.
- Driver requirements, Hall signals, encoder feedback and control inputs.
- Gearhead requirements and the point at which speed and torque are measured.
- Duty cycle, environmental conditions and the agreed validation method.
From review to sample evaluation
Confirm the configuration and the open questions before the sample is built. Use an agreed test plan to compare the sample with the equipment requirements. Availability, scope, timing and commercial terms are confirmed for the individual project.